Care and maintenance

  • The seat textile cover can be machine washed at 30º C on a gentle cycle. Do not put the cover in a dryer as this can damage the cover and the padding may separate from the fabric. Visit www.axkid.com to find videos explaining how to remove and attach the cover.
  • If the textile seat cover needs replacing, ensure only original products from Axkid are used. If other products are used, the Axkid car seat’s safety system may be compromised and could lead to severe injury in case of an accident.
  • Any plastic parts of the Axkid car seat can be cleaned with mild detergent and water. Do not use aggressive chemicals containing solvents or similar, as this can cause damage to the plastic and compromise the safety of the car seat.
  • Do not make any modifications or alterations to the Axkid car seat other than those described in this instruction manual.
  • Any repairs must be carried out by the manufacturer or agent.
  • Handle the car seat with care and clean it regularly for maximum durability.

Remove the textile cover

  • Remove the ASIP pad (I) if attached.
  • Pull the headrest (A) to its topmost position.
  • Loosen the harness by pressing the harness release button (E) and pull out both shoulder straps (R) at the same time.
  • Unzip the two zippers on the underside of the headrest (A) and carefully pull the cover off from the headrest (A).
  • Lower the headrest (A) to the lowest position.
  • Unlock the harness buckle by pressing the buckle release button (C) and remove the buckle cover.
  • Unzip the zipper and open the belt clamp lid (O) and remove the plastic lid from the textile cover.
  • Unzip the zipper underneath the car seat and open the 4 buttons on the textile cover on the backside of the car seat.
  • Unzip the two zippers at the backrest on the inside of the car seat and gently remove the textile cover from the car seat. Be careful around the ASIP pad and other plastic covers to avoid damaging the textile. Don’t pull too hard.
  • Open the shoulder pads and gently remove them from the shoulder straps (R).

Reinstall the textile cover

  • Reverse the steps from the instruction above to install the textile cover on the car seat again.

Note:
The shoulder pads can be installed at different positions. Install them in a position suitable for your child, the shoulder pads should be positioned on top of the shoulder and on the chest of your child. Also make sure that the rubber side of the shoulder pad is facing your child’s chest.