Safety information

Thank you for choosing Axkid MINIKID 4 MAX

Read this instruction manual before installing Axkid MINIKID 4 MAX car seat in your vehicle.

For more information and installation videos, visit www.axkid.com.

Axkid MINIKID 4 MAX is a rear-facing car seat approved for children with a height between 61-125 cm, ≤36 kg

Axkid MINIKID 4 MAX is suitable for use from approximately six months of age, or from when your child can sit up unsupported.

This is an integral Specific vehicle Belted Enhanced Child Restraint System. It is approved according to UN Regulation No. 129, for use in compatible vehicle seating positions as indicated by the vehicle list. If in doubt, consult either the Enhanced Child Restraint System manufacturer (www.axkid.com) or the retailer.

Safety information

To maximize your child’s safety, it is important that you keep the following in mind:

  • Always follow the instructions in this manual. An incorrect installation may seriously affect the safety for your child. If in doubt, contact your retailer who can demonstrate a correct installation.
  • Keep this instruction manual for future reference. If manual is lost, you can find it online at www.axkid.com
  • Do not use Axkid MINIKID 4 MAX car seat in a seating position where an active frontal airbag is fitted. If you still wish to install Axkid MINIKID 4 MAX car seat in this location the airbag must be switched off according to the vehicle manufacturers instructions.
  • Should you have an accident, no matter how small, your car seat should always be replaced. It may have damage that is not visible and could seriously affect the safety of your child. For this reason, Axkid does not recommend purchasing secondhand car seats.
  • If Axkid MINIKID 4 MAX car seat has been exposed to direct sunlight, make sure the car seat is not too hot before installing your child.
  • Never leave your child unattended in the vehicle.
  • Ensure that any luggage or loose objects are secured in your vehicle as they may cause injuries to passengers in the event of an accident.
  • Ensure that Axkid MINIKID 4 MAX car seat is installed in a way where no parts become trapped by movable seats, car doors, etc.
  • If you are using lower tether anchorage straps, make sure they are installed in a way where they don’t interfere with the movement of any vehicle seat.
  • Axkid MINIKID 4 MAX car seat may only be installed rear-facing.
  • Always make sure that the harness is adjusted to correctly fit your child’s body. The harness is adjusted by moving the head support.
  • Make sure that the child’s back is pushed against the car seat when restraining your child with the harness.
  • Always make sure that the harness is firmly tightened against your child and that the buckle is completely locked, you should not be able to pinch the straps.
  • Make sure there is no twist in the harness.
  • Always make sure the support leg is in its correct position and that is has contact with the vehicle floor. The support leg is a very important safety feature designed to maximise your child’s safety in an accident.
  • Do not attempt to disassemble or modify any part of the Axkid MINIKID 4 MAX car seat. The warranty and the safety performance of the Axkid MINIKID 4 MAX car seat could be affected if doing so.
  • Never use Axkid MINIKID 4 MAX car seat without the textile cover. The seat textile cover is a safety feature and may only be replaced with an Axkid original seat textile cover.
  • Read the vehicle handbook and the vehicle list at www.axkid.com to find which seating positions are suitable for this car seat.
  • Axkid recommends to always use a seat protection to protect your vehicle seat from scratches and dirt.
  • If you have any doubts, contact the retailer where the car seat was purchased or contact info@axkid.com